How To Change Tie Rod Ends

Locate the outer tie rod end. The inner tie rod end is greased and protected by the steering rack boot.

How To Replace Tie Rod Ends Yourmechanic Advice

These rods are connected to the steering system and then to the wheels.

How to change tie rod ends. How a Tie Rod Works. A tie-rod end puller or a similar tool is recommended to separate the tie-rod end from the wheel spindle. Then you just follow the simple steps in the article and corresponding video.

Both tie rod ends have ball joints. The outer tie rod end is also filled with grease but its protected by a small rubber or plastic boot. Shake the tie rod by hand to see if it feels loose.

Accessing the Tie Rod End 1. Finish taking the. Then push in with your left hand.

When you turn the steering wheel the rods roll over a slotted rack which makes the front tires turn. Next separate the tie-rod end from the wheel spindle. Use a pair of pliers to remove the cotter pin from the castle nut on the tie-rod end.

Theyre mounted to the steering knuckle and are generally 6 inches long with a ball joint at one end. Locate the tie rod ends under the vehicle. It is made up of an inner tie rod and an outer tie rod.

Clean it off and use a grease gun filled with the proper grease. How to Replace an Outer Tie End Safety First. Removing the boot on the tie rod unbolting the tie rod end removing the tie rod from the steering arm and the inner tie rod end and then reassembling the new tie rods.

Replacing your tie rod ends Step 1. Refer to your service manual for jacking points and jack up your car. The marks will help you replace the new rods in roughly the same position which will keep your alignment close to original.

An adjustment sleeve joins the tie rod to the steering linkage. At every oil change grease the tie rod ends. Locate the Outer Tie Rod End.

Look for a grease fitting on the outer edge by the bushing. Loosen the front tires slightly. Automotive repair DIY tips and tricks.

The new grease pushes out the old as well as any collected contaminants and road grit. While on the ground the cars. Mark the position of the tie rod end on steering assembly with chalk or electrical tape then remove by unscrewing.

Park the car on a flat surface and loosen the lug nuts. 7 If your particular tie rod ends come with grease fittings install them now. Use the floor jack to raise the front tires off the ground and secure the vehicle in the air.

Raise the front end with a floor jack. Then unbolt the castle nut from the tie-rod end. The rods will either push or pull the tires depending on which way youre turning.

The ball with stud and locking nut attaches to the steering. Picked Fork Kit on Amazon - httpamznto2Hr3Blazer Jimmy S10 Replacement Tie Rod Ends on Amazon - httpamznto2CeBhyVGrease Gun on Amazon - https. How to replace inner and outer tie rods.

Park your vehicle on a flat dry surface and install wheel chocks. Locate the Inner Tie Rod. Wear appropriate gloves and safety.

A tie rod is made of two components. Get a good grip on the rubber. Kneel in front of the tire placing your hands along its sides.

This video will show you in depth how to change the inner and outer tie rods of your car or truck. 709 members in the DIYAutoRepair community. Part 1 of 1.

In this video I am going to replace the inner and outer tie rods on a 2010 ford fusion. This should be done with a tire iron or impact wrench. You need a specia.

The inner and outer tie rod ends. Most of the time without the need to realign the vehicle. Use your breaker bar and correct size socket to bust.

Beyond that there is the matter of lifting the vehicle and removing the tires.

How To Replace Outer Tie Rod Ends